SMPS Switching Power Supply 24V 6A: A device that can provide stable and reliable DC power for various applications. It accepts a wide range of AC input voltage from 90 to 264 V AC or 120 to 375 V DC. It uses a primary switch mode technology that switches the input voltage on and off at a high frequency, which reduces the size and weight of the transformer and the filter capacitor. It also improves the conversion efficiency, which can reach up to 95%2. It delivers a regulated DC output voltage of 24V and a maximum output current of 5A.
4080 profile is one of the most widely used industrial framework profiles, as it has a general scope of strength and tension so as to apply to framework combination as well as assembly line, equipment rack, workbench, fence and storage rack etc. And it’s mainly used to assembly variety of much larger intensity structural framework.
This is a smart LCD display that can control your 3D printer without a PC. It has a 128 x 64 dot matrix screen, a rotary encoder, and an SD card reader. It can connect to your RAMPS 1.4 board using the included smart adapter. You can print your 3D models from the SD card, adjust the parameters, and monitor the status of your printer.
It is a Mega Pololu Shield, or RAMPS for short,designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion. The modular design includes plug in for stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion. Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.This board is mostly based on Adrian's Pololu_Electronics and work by Tonok. Copper etch resists methods suggested by Vik. Also inspired by Vik's work with EasyDrivers. circuit design based mostly on Adrian's Pololu_Electronics Joaz at RepRapSource.com supplied initial pin definitions and many design improvements. Much inspiration, suggestions, and ideas from Prusajr, Kliment, Maxbots, Rick, and many others in the RepRap community.
This is a 5V 8-Channel Relay interface board be able to control various appliances, and other equipments with large current It can be controlled directly by Micro-controller (Arduino UNO, MEGA, PRO, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic)5V 4-Channel Relay interface board, and each one needs 50-60mA Driver Current Equiped with high-current relay, AC250V 10A ; DC30V 10A
JUTHOURTECH JUTHOURTECH