
Study ultrasonic sensing on a guarded well scale model and document the environmental failures that make physical barriers indispensable.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno, an HC-SR04 ultrasonic sensor, an HC-05 Bluetooth module, a buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the buzzer to pin 3, and the LED to pin 4. The HC-05 communicates over software serial through pins 10 and 11.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Use only a sealed miniature model. Test different approach angles, small targets, wind, rain, dust, vegetation, sensor blockage, multiple targets, power loss, and alarm failure.
Use limitations
Never test at a real open well or rely on an alarm. Install a secure cover or code-compliant guard, restrict access, maintain the site, and follow local safety requirements.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment