Why an Arduino Edge-Alert Demo Is Not Fall Protection

Why an Arduino Edge-Alert Demo Is Not Fall Protection

Use a tabletop edge model to study sensor failure modes and explain why guardrails, fall arrest, training, and certified controls remain essential.

This experiment is not fall protection and must never be relied on near a real edge. Use engineered guardrails, fall-arrest systems, exclusion zones, training, supervision, and applicable workplace regulations.

Prototype objective

This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.

Suggested components

An Arduino Uno, an HC-SR04 ultrasonic sensor, a 5V active buzzer, a yellow LED, an HC-05 Bluetooth module, a breadboard, and jumper wires.

Wiring and implementation

The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the buzzer connects to pin 3, the LED to pin 4, and the HC-05 connects over software serial on pins 10 and 11 at 9600 baud.

Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.

Test plan

Demonstrate missed detections with clothing, angles, dust, rain, and multiple people, then document the hazard controls that must exist independently of the sensor.

Use limitations

This experiment is not fall protection and must never be relied on near a real edge. Use engineered guardrails, fall-arrest systems, exclusion zones, training, supervision, and applicable workplace regulations.

Next step

Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.

Leave your comment

*
*
Only registered users can leave comments.