Why a Stove Proximity Demo Is Not Child Protection

Why a Stove Proximity Demo Is Not Child Protection

Test proximity logic around a cold miniature stove model and document why barriers, supervision, and appliance controls must provide the real protection.

Do not use this prototype near a real stove or rely on it for child safety. Use supervision, stable barriers, control locks, and the appliance maker's safety guidance.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno R3, an HC-SR04 ultrasonic sensor, an HC-05 Bluetooth module, a yellow LED, an active buzzer, an 830-point breadboard, and jumper wires.

Wiring and implementation

The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the buzzer connects to pin 3, the LED to pin 4, and the HC-05 connects over software serial on pins 10 and 11.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Keep the model cold and de-energized. Test side approaches, low targets, steam-like interference, blocked sensing, multiple targets, alarm fatigue, and complete power loss.

Use limitations

Do not use this prototype near a real stove or rely on it for child safety. Use supervision, stable barriers, control locks, and the appliance maker's safety guidance.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

Leave your comment

*
*
Only registered users can leave comments.