Building an Adjustable Screen-Distance and Break Reminder

Building an Adjustable Screen-Distance and Break Reminder

Create a gentle distance and break reminder with adjustable thresholds, quiet cues, snooze, and user-controlled timing on a stationary desk model.

The device does not protect eyesight, diagnose a vision problem, or define one correct distance. Ergonomics vary; persistent symptoms or vision changes require qualified eye care.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

A Wemos D1 board, an HC-SR04 ultrasonic sensor, an active buzzer, a breadboard, and jumper wires.

Wiring and implementation

The HC-SR04's Trig pin connects to D3 and Echo to D4, with the buzzer on D2.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Co-design the interaction with intended users; test reach, force, timing, visual, audio and haptic alternatives, false and missed activation, privacy, power loss, and a reliable manual alternative.

Use limitations

The device does not protect eyesight, diagnose a vision problem, or define one correct distance. Ergonomics vary; persistent symptoms or vision changes require qualified eye care.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

Leave your comment

*
*
Only registered users can leave comments.