
Model contact-light credential presentation, clear feedback, timed opening, manual assistance, and safe egress on a miniature accessible doorway.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
A Wemos-compatible board, an RC522-class RFID reader with blank tokens, a miniature door operator, obstruction sensor, manual release and assistance buttons, local feedback, breadboard, and jumper wires.
Wiring and implementation
Connect the RFID reader over its documented SPI interface using 3.3 V logic, the model operator through a separate suitable supply and driver, and the obstruction and manual controls to supervised inputs. Never block manual egress.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test valid and revoked credentials, reach and feedback, obstruction, actuator jam, repeated requests, network and power loss, manual release, emergency egress, and accessible alternatives.
Use limitations
A hobby reader does not make a door accessible or secure. Real systems need user co-design, reachable controls, rated operators, obstruction protection, emergency egress, and qualified installation.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment