
Use a magnetic reed switch and configurable delay to detect an open door, sound a local reminder, and optionally send a Wi-Fi notification.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
A Wemos-compatible board, a magnetic reed switch and magnet, local buzzer through a suitable driver, acknowledgement button, regulated supply, breadboard, and jumper wires.
Wiring and implementation
Connect the reed switch to a digital input with a pull-up, debounce state changes, start a nonblocking delay when the door opens, and drive the local buzzer through a suitable interface.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test debounce, short and long activation, a stuck or disconnected switch, accidental presses, acknowledgement, retry and escalation timing, battery state, network loss, and a local fallback.
Use limitations
The alert is a convenience feature, not proof of food safety or appliance health. Keep wiring outside sealed and cold zones and follow the appliance manufacturer's guidance.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment