
Test high-level detection on a small contained pool model with local alarms, Wi-Fi notification, sensor-fault handling, and an overflow catch tray.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
A Wemos D1 board, a water-level sensor, an active buzzer, a breadboard, and jumper wires.
Wiring and implementation
The sensor connects to pin D4 and the buzzer to pin D2.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test empty, partial, and full states with uneven and angled targets; record blind zones, condensation, dust or splashes, stale readings, sensor faults, power loss, and communication failure.
Use limitations
The alert does not replace correctly sized overflow drains, level controls, barriers, supervision, or electrical safety around pools. Use rated pool equipment for any deployment.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment