
Create a customizable meal-time reminder whose schedule, prompts, and foods reflect the user's preferences rather than medical or nutrition advice.
Prototype objective
This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.
Suggested components
An Arduino Uno, a 16x2 I2C LCD (address 0x27), an RGB LED, an active buzzer, a push button, a breadboard, and jumper wires.
Wiring and implementation
The green LED connects to pin 10, blue to pin 11, and red to pin 12, the buzzer connects to pin 8, and the button connects to pin 9 with an internal pull-up configuration.
Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.
Test plan
Test clock rollover, missed acknowledgements, and power loss; let users edit all labels and avoid prescriptive meal or portion recommendations.
Use limitations
The device is a personal reminder, not a nutrition or medication system. Medical diets, allergies, diabetes, eating disorders, and medication-linked meals require qualified advice and independent safeguards.
Next step
Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.
Leave your comment