Building a Customizable Daily Activity Prompt

Building a Customizable Daily Activity Prompt

Create an optional, privacy-aware prompt for chosen daily activities with user-controlled timing, wording, sound, and dismissal.

A proximity reading cannot identify loneliness, isolation, or mental state. This device is a voluntary reminder, not monitoring, diagnosis, treatment, or a substitute for human support.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno R3, an HC-SR04 ultrasonic sensor, an active buzzer, a yellow LED, an HC-05 Bluetooth module, a breadboard, and jumper wires.

Wiring and implementation

The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the buzzer connects to pin 3, the LED to pin 4, and the HC-05 connects over software serial on pins 10 and 11.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Let the user choose every prompt and schedule; test quiet hours, easy dismissal, repeat frequency, power loss, privacy, and whether the device remains welcome over time.

Use limitations

A proximity reading cannot identify loneliness, isolation, or mental state. This device is a voluntary reminder, not monitoring, diagnosis, treatment, or a substitute for human support.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

Leave your comment

*
*
Only registered users can leave comments.