Building a Configurable Weekly Task Reminder

Building a Configurable Weekly Task Reminder

Store and present a configurable weekly task list with clear navigation, acknowledgement, and nonvolatile settings where appropriate.

A reminder can support memory but cannot guarantee task completion or medication adherence. Safety-critical schedules need purpose-built systems, escalation, and human oversight.

Prototype objective

This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.

Suggested components

An Arduino Uno R3, a 16x2 I2C LCD (address 0x27), a push button, an active buzzer, a yellow LED, a breadboard, and jumper wires.

Wiring and implementation

The button connects to digital pin 2, the buzzer connects to pin 4, the LED to pin 3, and the LCD uses the standard SDA and SCL pins at address 0x27.

Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.

Test plan

Test date rollover, daylight-saving assumptions, acknowledgement, missed tasks, power loss, and a simple editing flow for the user or caregiver.

Use limitations

A reminder can support memory but cannot guarantee task completion or medication adherence. Safety-critical schedules need purpose-built systems, escalation, and human oversight.

Next step

Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.

Leave your comment

*
*
Only registered users can leave comments.