
Create a respectful entrance reminder with adjustable visual or quiet cues, without attempting to control or jam visitors' phones.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a 16x2 I2C LCD, a yellow LED, an active buzzer, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 12 and 13, the LED connects to pin 4, the buzzer to pin 3, and the LCD uses standard I2C wiring.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test detection range, entry and exit direction, crowding, quiet-mode brightness, repeat delay, false triggers, accessibility, and easy disablement by authorized staff.
Use limitations
The device is a courtesy reminder only. It must not transmit interference, access phones, record visitors, or create a distracting sound at a mosque or other quiet space.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment