
Build a configurable play-and-break timer that provides reminders without pretending to enforce healthy behavior or replace parental settings.
Prototype objective
This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.
Suggested components
An Arduino Uno, a 16x2 I2C LCD (address 0x27), a push button, an active buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The button connects to pin 2, the buzzer to pin 3, the LED to pin 4, and the LCD uses I2C wiring at address 0x27.
Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.
Test plan
Test pause, resume, power loss, and configuration changes; keep reminders dismissible and avoid lockouts that could interfere with other device functions.
Use limitations
A reminder cannot enforce healthy gaming habits. Keep it configurable and respectful, and use platform or family controls when actual limits are required.
Next step
Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.
Leave your comment