
Prototype a removable moisture pad and local alert on an isolated bench model, with dignity, privacy, cleaning, and caregiver workflow in mind.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, a water/moisture sensor, an HC-05 Bluetooth module, a buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The moisture sensor's digital output connects to pin 2, the buzzer to pin 3, and the LED to pin 4. The HC-05 communicates over software serial through pins 10 and 11.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Use synthetic test liquid on a bench pad; test small and large wet areas, pressure, cable disconnection, false alarms, cleaning, alarm acknowledgement, and communication loss.
Use limitations
This is not medical equipment and must not contact a patient until a suitable certified product and clinical process are selected. Protect dignity, consent, and personal data.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment