
Build a low-voltage floor leak detector with a replaceable probe, local alarm, optional Wi-Fi notification, and explicit handling of corrosion and link loss.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
A Wemos D1 board, a water sensor, an active buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The water sensor connects to pin D4, the buzzer to pin D2, and the LED to pin D1.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test dry, damp, droplet, and spreading-water states; condensation, contamination, drying time, sensor corrosion, cable faults, local alarm operation, power loss, and notification failure.
Use limitations
The alert does not prevent flooding or make a basement electrically safe. Correct drainage and plumbing, keep mains equipment above water risk, and use rated shutoff products where needed.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment