Building a 20-20-20 Screen-Break Reminder

Building a 20-20-20 Screen-Break Reminder

Create a gentle 20-20-20 habit reminder with adjustable timing and quiet cues; it supports breaks but does not diagnose or treat eye conditions.

The 20-20-20 pattern is a general break habit, not a diagnosis or treatment. Persistent pain, vision change, or headaches should be evaluated by an eye-care professional.

Prototype objective

This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.

Suggested components

An Arduino Uno, a 16x2 I2C LCD (address 0x27), a push button, an active buzzer, a yellow LED, a breadboard, and jumper wires.

Wiring and implementation

The button connects to pin 2, the buzzer to pin 4, the LED to pin 3, and the LCD uses I2C wiring at address 0x27.

Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.

Test plan

Verify long-duration timing without delay(), provide snooze and quiet modes, and make the interval adjustable for comfort and accessibility.

Use limitations

The 20-20-20 pattern is a general break habit, not a diagnosis or treatment. Persistent pain, vision change, or headaches should be evaluated by an eye-care professional.

Next step

Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.

Leave your comment

*
*
Only registered users can leave comments.