
Build an isolated low-voltage test tray that senses water and explores alert timing without presenting the circuit as fall prevention.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a digital water sensor module, an active buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the water sensor connects to pin 13, the buzzer to pin 3, and the LED to pin 4.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Use only a shallow bench tray and battery power. Test droplets, puddles, condensation, soap residue, drying time, sensor corrosion, cable faults, and alarm audibility.
Use limitations
The alert does not prevent a fall and hobby electronics do not belong in wet zones. Use non-slip surfaces, grab rails, drainage, supervision, and compliant bathroom equipment.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
Leave your comment