Bench-Testing an RFID Vehicle-Gate Event Logger

Bench-Testing an RFID Vehicle-Gate Event Logger

Record authorized entry and exit events at two miniature gates with duplicate handling, offline queues, clock synchronization, and manual correction.

RFID gate events do not track vehicle movement or driver behavior. Real fleet systems require secure identities, privacy rules, rated gates, safety sensors, audit controls, and possibly telematics.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

Two Wemos D1 boards, two 13.56MHz RFID reader modules with cards or keychains, two active buzzers, breadboards, and jumper wires.

Wiring and implementation

Each RFID reader's RST pin connects to D3 and SS pin to D4, with its buzzer on D2.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Test valid, revoked, duplicate, forgotten, and unreadable tokens; repeated scans, offline queues, clock accuracy, manual correction, log integrity, privacy, and recovery after power loss.

Use limitations

RFID gate events do not track vehicle movement or driver behavior. Real fleet systems require secure identities, privacy rules, rated gates, safety sensors, audit controls, and possibly telematics.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

Leave your comment

*
*
Only registered users can leave comments.