
Evaluate distance zones, timeout handling, and alert behavior on a stationary parking model—not on a road vehicle or as a certified parking sensor.
Prototype objective
This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, an active buzzer, a yellow LED, an HC-05 Bluetooth module, an 830-point breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 5 and 6 respectively, the buzzer connects to pin 3, the LED to pin 4, and the HC-05 connects over software serial on pins 10 and 11.
Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.
Test plan
Move a flat target through each zone, include angled and absorbent targets, force an echo timeout, and confirm that stale measurements cannot hold an unsafe state.
Use limitations
Ultrasonic bench results do not qualify the device for a vehicle. Automotive parking functions require rated sensors, environmental and EMC testing, fail-safe behavior, and installation by qualified specialists.
Next step
Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.
Leave your comment