Bench-Testing a Heat-Stress Monitoring Prototype

Bench-Testing a Heat-Stress Monitoring Prototype

Measure temperature and humidity, calculate a screening indicator, and compare it with a calibrated reference under controlled conditions.

Temperature and humidity alone do not replace a validated WBGT program, work-rest policy, hydration, acclimatization, supervision, or occupational-health requirements.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno R3, an SHT31-class temperature and humidity sensor, a ventilated radiation shield, an isolated low-voltage warning light and buzzer, a breadboard, and jumper wires.

Wiring and implementation

Connect the SHT31 over I2C using the module voltage specified by its manufacturer. Keep the sensor in a ventilated shield away from board heat, and drive the buzzer or lamp through a suitable low-voltage interface stage.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Use an SHT31-class sensor in a ventilated shield, compare readings with a calibrated reference at several conditions, log stabilization time, and test sensor and power faults.

Use limitations

Temperature and humidity alone do not replace a validated WBGT program, work-rest policy, hydration, acclimatization, supervision, or occupational-health requirements.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

Leave your comment

*
*
Only registered users can leave comments.