Why a Rooftop Edge Alert Is Not Fall Protection

Why a Rooftop Edge Alert Is Not Fall Protection

Use a guarded scale model to expose sensor blind spots and show why physical access control and certified fall protection must work independently.

Never rely on this circuit near a real roof edge. Restrict access and use code-compliant guardrails, fall-arrest systems, supervision, training, and qualified safety engineering.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno R3, an HC-SR04 ultrasonic sensor, an HC-05 Bluetooth module, a buzzer, a yellow LED, a breadboard, and jumper wires.

Wiring and implementation

The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the buzzer to pin 3, and the LED to pin 4. The HC-05 communicates over software serial through pins 10 and 11.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Test only on a miniature model with low and angled targets, clothing-like material, wind and rain simulation, sensor blockage, multiple targets, communication loss, and power failure.

Use limitations

Never rely on this circuit near a real roof edge. Restrict access and use code-compliant guardrails, fall-arrest systems, supervision, training, and qualified safety engineering.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.