
Demonstrate proximity sensing beside a model bed while explaining why distance alone cannot control infection risk or replace hospital procedures.
Prototype objective
This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a 16x2 I2C LCD, an active buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 12 and 13, the buzzer connects to pin 3, the LED to pin 4, and the LCD uses standard I2C wiring.
Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.
Test plan
Show how people, bedding, equipment, and sensor angle change readings; do not map a single distance threshold to infection risk.
Use limitations
Distance is not a validated proxy for infection risk. This tabletop exercise is not medical equipment and must not guide patient placement, isolation, or clinical decisions.
Next step
Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.
اترك تعليقا