
Encode measured distance as adjustable audio feedback in a supervised prototype that does not replace a cane, guide dog, or certified mobility aid.
Prototype objective
This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.
Suggested components
An Arduino Uno, an HC-SR04 ultrasonic sensor, an active buzzer, a 16x2 I2C LCD, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 12 and 13, the buzzer connects to pin 3, and the LCD uses standard I2C wiring.
Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.
Test plan
Test several object sizes and angles, cap sound level, add mute and sensitivity controls, and evaluate the cue with users in a safe stationary environment.
Use limitations
The prototype has limited field of view and can miss small, soft, angled, or moving obstacles. It must not replace established mobility aids, orientation training, or certified assistive technology.
Next step
Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.
اترك تعليقا