Designing a Touch-Free Proximity-Control Prototype

Designing a Touch-Free Proximity-Control Prototype

Prototype touch-free switching with deliberate dwell time and feedback, then validate the interaction with the intended user before any assistive use.

A useful assistive product must be co-designed and validated with its users. This circuit is an interaction experiment, not a medical device and not evidence that one gesture suits every disability.

Prototype objective

This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.

Suggested components

An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a 16x2 I2C LCD, an active buzzer, a blue LED, a breadboard, and jumper wires.

Wiring and implementation

The HC-SR04's Trig and Echo pins connect to pins 12 and 13 respectively, the LED connects to pin 4, the buzzer to pin 3, and the LCD uses the standard SDA and SCL pins for I2C.

Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.

Test plan

Measure repeatability across hand positions and clothing, add dwell and hysteresis, and let intended users evaluate reach, feedback, fatigue, and accidental activation.

Use limitations

A useful assistive product must be co-designed and validated with its users. This circuit is an interaction experiment, not a medical device and not evidence that one gesture suits every disability.

Next step

Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.