
Prototype RFID authorization and barrier state logic on a miniature rig with obstruction sensing, manual release, and logged test events.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, an RC522 RFID reader module, a servo motor, an active buzzer, a breadboard, and jumper wires.
Wiring and implementation
The RC522 communicates over SPI, with its SS pin on pin 10 and RST pin on pin 9. The servo connects to pin 6 and the buzzer to pin 5.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Use only a scale model. Test valid and revoked cards, tailgating simulation, obstruction, servo jam, repeated scans, power loss, manual release, and safe default states.
Use limitations
Do not connect this prototype to a real barrier. Vehicle gates require rated operators, safety edges and loops, emergency procedures, secure access control, and qualified installation.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
اترك تعليقا