Building an RFID Cafeteria Queue Demonstrator

Building an RFID Cafeteria Queue Demonstrator

Model check-in and queue states with blank RFID cards, privacy-minimized records, accessible feedback, and a manual path for exceptions.

Do not use the prototype to deny food, track children unnecessarily, or expose identities. A real school system requires safeguarding, consent, minimal data, accessibility, and staff oversight.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno R3, an RC522 RFID reader module, an SG90 servo motor, an active buzzer, a breadboard, and jumper wires.

Wiring and implementation

The RC522 communicates over SPI, with its SS pin on pin 10 and RST pin on pin 9. The servo connects to pin 6 and the buzzer to pin 5.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Test valid, duplicate, forgotten, and unreadable cards; offline mode, peak scan rate, accessible feedback, manual override, data deletion, and equitable exception handling.

Use limitations

Do not use the prototype to deny food, track children unnecessarily, or expose identities. A real school system requires safeguarding, consent, minimal data, accessibility, and staff oversight.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.