
Create a configurable study prompt with short tasks, large controls, and multimodal feedback shaped with learners, families, and educators.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, a pull-up push button, a 16x2 I2C LCD (address 0x27), an active buzzer, a breadboard, and jumper wires.
Wiring and implementation
The push button connects to pin 2, the buzzer to pin 3, and the LCD uses I2C wiring at address 0x27.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test reading level, contrast, button force, timing, quiet mode, repeat and skip controls, accidental input, and whether the learner can change or reject the prompts.
Use limitations
Learning needs differ widely. The device is an adaptable aid, not an assessment or treatment, and should be co-designed rather than used to label or pressure a learner.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
اترك تعليقا