Building an Accessible Dhikr Counter with Arduino

Building an Accessible Dhikr Counter with Arduino

Build a large-button, high-contrast counter with adjustable phrases and counts, designed around the preferences and abilities of the intended user.

Religious wording and counting preferences vary. Make phrases and goals editable, protect privacy, and treat the device as an optional convenience rather than a religious authority.

Prototype objective

This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.

Suggested components

An Arduino Uno R3, a 16x2 I2C LCD, a push button, an active buzzer, an 830-point breadboard, and jumper wires.

Wiring and implementation

The button connects to digital pin 2 with an internal pull-up enabled, the buzzer connects to pin 3, and the LCD uses serial I2C wiring needing just two signal lines, noticeably simplifying the connections.

Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.

Test plan

Test button force, debounce, text size, contrast, audio alternatives, accidental resets, and nonvolatile count recovery with the intended user.

Use limitations

Religious wording and counting preferences vary. Make phrases and goals editable, protect privacy, and treat the device as an optional convenience rather than a religious authority.

Next step

Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.