
Build a touch-free meal-time hygiene prompt with adjustable timing and feedback while keeping health claims out of the prototype.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a 16x2 I2C LCD (address 0x27), an active buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 12 and 13, the LED connects to pin 4, the buzzer to pin 3, and the LCD uses I2C wiring at address 0x27.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Test hand distance, approach angle, sleeves, repeated activation, timeout, quiet mode, cleaning compatibility, and whether users understand and accept the cue.
Use limitations
A reminder cannot verify washing quality or prevent disease. Follow current hygiene guidance and use surfaces and enclosures that can be cleaned safely.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
اترك تعليقا