Building a Privacy-Aware RFID Attendance Demonstrator

Building a Privacy-Aware RFID Attendance Demonstrator

Model attendance events with blank RFID tokens, duplicate-scan handling, offline operation, corrections, minimal records, and staff review.

Do not infer absence solely from a missed scan or expose student records. Real deployment requires safeguarding, consent, secure identities, correction rights, retention limits, and alternatives.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

A Wemos D1 board, a 13.56MHz RFID reader/writer module, an active buzzer, a breadboard, and jumper wires.

Wiring and implementation

The RFID reader's RST pin connects to D3 and SS pin to D4, with the buzzer on D2.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Test valid, revoked, duplicate, forgotten, and unreadable tokens; repeated scans, offline queues, clock accuracy, manual correction, log integrity, privacy, and recovery after power loss.

Use limitations

Do not infer absence solely from a missed scan or expose student records. Real deployment requires safeguarding, consent, secure identities, correction rights, retention limits, and alternatives.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.