Building a Guided Breathing Pacer with Arduino

Building a Guided Breathing Pacer with Arduino

Build a calm visual breathing pacer with adjustable inhale, pause, and exhale timing plus a simple stop control and optional sound.

This is a relaxation timer, not respiratory treatment or emergency equipment. Users should stop if uncomfortable and follow qualified medical advice for breathing conditions.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno R3, a 16x2 I2C LCD (address 0x27), a yellow LED, an active buzzer, a breadboard, and jumper wires.

Wiring and implementation

The LED connects to pin 3 and the buzzer to pin 4. The LCD uses I2C wiring at address 0x27.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Test timing accuracy without blocking delays, brightness and sound controls, immediate stop, power recovery, and a comfortable default selected with intended users.

Use limitations

This is a relaxation timer, not respiratory treatment or emergency equipment. Users should stop if uncomfortable and follow qualified medical advice for breathing conditions.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.