
Test liquid sensing on an isolated bench model only; never attach an Arduino prototype to medical equipment or use it for patient safety decisions.
Prototype objective
This project focuses on measurement, state logic, feedback, and a low-voltage bench prototype that can be tested safely before any more advanced application is considered.
Suggested components
An Arduino Uno R3, a water sensor (depth detection module), an HC-05 Bluetooth module, an active buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The water sensor connects to digital pin 2, the buzzer connects to pin 3, the LED to pin 4, and the HC-05 connects over software serial — receive on pin 10, transmit on pin 11.
Use a regulated supply and common ground, drive loads through suitable interface stages, add flyback protection for inductive loads, and condition logic levels where required.
Test plan
Use only water and low-voltage isolated loads on the bench; test sensor corrosion, splashes, cable faults, local alarms, and communication loss.
Use limitations
Do not connect this prototype to medical equipment, power circuits, alarms, or patient-care workflows. Clinical environments require certified equipment, risk management, electrical safety, and hospital approval.
Next step
Document the schematic, library versions, measurements, and failure cases before extending the prototype, and consult qualified specialists and applicable standards whenever safety, health, vehicles, or industrial equipment are involved.
اترك تعليقا