
Explore non-contact distance feedback on a supervised training model, with adjustable thresholds and respect for individual ability and practice.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a 16x2 I2C LCD (address 0x27 or 0x3F), a buzzer, a yellow LED, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 12 and 13, the buzzer to pin 3, and the LED to pin 4. The LCD uses I2C wiring at address 0x27 or 0x3F depending on the module.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Calibrate only with consenting users in a safe open area, test clothing and body variation, provide silent and disable modes, and check for false feedback from adjacent movement.
Use limitations
Distance does not determine whether prayer is valid or posture is suitable. The tool is optional, not a religious or medical authority, and must accommodate disability and comfort.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
اترك تعليقا