Bench-Testing an RFID Building-Entry Prototype

Bench-Testing an RFID Building-Entry Prototype

Build a tabletop RFID access demo with explicit authorization states, event logging, manual release, and safe behavior when power or communication fails.

RC522 cards and a hobby servo are not a secure building-access system. Real deployment needs secure credentials, rated locks, fire-code egress, privacy controls, and qualified integration.

Prototype objective

The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.

Suggested components

An Arduino Uno, an RC522 RFID reader module, a servo motor, an active buzzer, a breadboard, and jumper wires.

Wiring and implementation

The RC522 communicates over SPI, with its SS pin on pin 10 and RST pin on pin 9. The servo connects to pin 6 and the buzzer to pin 5.

Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.

Test plan

Test valid, revoked, duplicate, and unreadable cards; repeated scans, power loss, reader disconnection, servo jam, log integrity, manual release, and emergency egress behavior.

Use limitations

RC522 cards and a hobby servo are not a secure building-access system. Real deployment needs secure credentials, rated locks, fire-code egress, privacy controls, and qualified integration.

Next step

Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.

اترك تعليقا

*
*
يمكن للأعضاء المسجلين فقط ترك تعليقات.