
Evaluate an isolated textile moisture patch and privacy-safe notification on synthetic samples without interpreting the signal as a health condition.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
A Wemos D1 board, a moisture sensor, an active buzzer, a breadboard, and jumper wires.
Wiring and implementation
The sensor connects to pin D4 and the buzzer to pin D2.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Co-design the interaction with intended users; test reach, force, timing, visual, audio and haptic alternatives, false and missed activation, privacy, power loss, and a reliable manual alternative.
Use limitations
This is not a wearable medical device and cannot measure or diagnose excessive sweating. Body-contact products require safe materials, electrical isolation, cleaning validation, consent, and clinical review.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
اترك تعليقا