
Study proximity sensing on a miniature balcony model and document blind zones, false alarms, and the safeguards that must remain independent.
Prototype objective
The project focuses on sensing, state logic, feedback, and a low-voltage bench prototype that can be tested safely. Define user requirements, success criteria, and failure cases before considering any real deployment.
Suggested components
An Arduino Uno R3, an HC-SR04 ultrasonic sensor, a 5V active buzzer, a yellow LED, an HC-05 Bluetooth module, a breadboard, and jumper wires.
Wiring and implementation
The HC-SR04's Trig and Echo pins connect to pins 5 and 6, the buzzer connects to pin 3, the LED to pin 4, and the HC-05 connects over software serial on pins 10 and 11.
Use a regulated supply and common ground, never drive loads directly from controller pins, and add current limiting, suitable interface stages, flyback protection for inductive loads, and logic-level conditioning as required.
Test plan
Use only a guarded scale model. Test small and angled targets, sunlight, curtains, rain simulation, multiple targets, blocked sensors, communication loss, and power failure.
Use limitations
This prototype is not child protection and must never replace locked access, code-compliant balcony guards, supervision, or other engineered barriers.
Next step
Document the schematic, library versions, calibration, measurements, and failure cases. Whenever the application involves safety, health, children, buildings, or equipment, use qualified specialists and applicable standards rather than relying on a hobby prototype.
اترك تعليقا